2 Sets Of - Front Stabilzier Sway Bar Links For 2005 2006 08-2012 Nissan Pathfinder

2 Sets of - Front Stabilzier Sway Bar Links For 2005 2006 08-2012 Nissan Pathfinder Every set can be described as following: Fitting the Following vehicle: 2005 - 2013 NISSAN FRONTIER All Models 2005 - 2012 NISSAN PATHFINDER All Models 2005 - 2013 NISSAN XTERRA All Models Package Includes: 1x Front Left Stabilizer / Sway Bar End Link - K80470 1x Front Right Stabilizer / Sway Bar End Link - K80471 Note Although some parts have grease fittings, other parts are factory sealed, but do not affect the fit and quality of the parts 10 Year Warranty Please check above compatibility list to make sure it fits your vehicle Sway Bar Some control arm bushings can be replaced with the arm still on the vehicle; others require removal of the arm. On a few applications, control arm bushings are threaded into the control arm, but most are press fitted Press fitted bushings can be removed and installed with a bushing driver. Some may be removed with an air chisel, and some may be pressed into the arm with the retaining nut. This method can require periodic vibration of the control arm to coax the bushing into place Care must be used in bushing replacement to avoid damage to the control arm. To properly position the bushing, the weight of the vehicle must be on the suspension before tightening the nut on most designs. Check the service information for the vehicle for the proper procedure Replacement of other types of suspension bushings is generally straightforward. Consult the service information Sway Bar Stabilizer Link Replacement Guideline: While driving, the following signs may indicate a faulty sway bar stabilizer link: (1).Rattling and thumping noises on rough roads (3).Stronger inclination of the vehicle during cornering If the sway bar stabilizer link is found to be defective, it should be replaced as described below 1.Raise vehicle and remove front wheels Tip:Always check both stabilizer links and replace them in pairs if necessary 2.Spray fastening nuts of the stabilizer link with rust remover and let act for a few minutes 3.Loosen the lower fastening nut of the stabilizer link at the stabilizer and remove Tip:If the ball stud also starts to turn, hold it with a suitable tool 4.Press stabilizer link out of torsion bar 5.Loosen the upper fastening nut of the stabilizer link at the suspension strut and remove it 6.Press stabilizer link at suspension strut out of bracket 7.Insert new stabilizer link at suspension strut 8.Tighten stabilizer link at suspension strut to the tightening torque specified by the vehicle manufacturer Tip:Secure the ball stud against twisting with a suitable tool 9.Insert new stabilizer link at stabilizer 10.Tighten stabilizer link at stabilizer to the tightening torque specified by the vehicle manufacturer 11.Remount the front wheels. Lower the vehicle and tighten the wheel studs to the tightening torque specified by the vehicle manufacturer Tip:Even if replacing the stabilizer link does not directly affect the chassis setting, we recommend checking the axle setting and adjusting if necessary after working on the suspension 12.Conclude with a test drive Frequently Asked Questions (1).What is sway bar? (2).What are the symptoms of a bad sway bar? (3).What happens when a stabilizer bar breaks? (4).What is the most important tip to offer to help with anti-sway bar installation? The most important thing is to ensure is that your wheels are not hanging. The suspension should be compressed so the control arms, etc. are at the same position they would be if the vehicle were sitting at ride height. This can be done by using ramps, a drive on lift, or simply loading the wheels if the vehicle is on jack stands or a two point lift. If this is not done the arc that the bar and suspension moves through due to the excessive travel can make things very difficult to line up (5).How long will it take to replace the front sway bar?